424 Upgrade and Maintenance Manual TX2550 M4
System board and components
Figure 303: Removing the TPM spacer
Ê Using a pair of flat nose pliers, press together the hooks on the TPM spacer
(see arrows) and remove it from the system board.
I If the TPM is to be replaced, the TPM spacer may remain on the
system board.
Ê Install the system board, see section "Installing the new system board" on
page 454.
14.3.2.3 Concluding steps
Ê Install the fan bridge, see section "Handling fan bridges" on page 90.
Ê "Installing the crossbar" on page 89
Ê If applicable, "Installing the riser module" on page 85
Ê "Installing the PCI air duct" on page 87
Ê "Installing the system air duct" on page 68
Ê "Reassembling" on page 68
Ê "Connecting the power cord" on page 81
Ê "Switching on the server" on page 82
To Next Page
Loading...
