Fujitsu PRIMERGY TX2550 M4 - Upgrading to 8 X 3.5-Inch HDD Configurations; Preliminary Steps; Removing the 3.5-Inch HDD Bay Top Cover

234 Upgrade and Maintenance Manual TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
7.4.10 Upgrading to 8x 3.5-inch HDD configurations
7.4.10.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 105
Ê "Shutting down the server" on page 52
Ê "Disconnecting the power cord" on page 53
Ê "Getting access to the component" on page 54
Ê Remove all HDD modules, see section "Removing 3.5-inch HDD modules"
on page 220.
Ê "Removing the system air duct" on page 67
Ê Remove the fan bridge, see section "Handling fan bridges" on page 90.
7.4.10.2 Removing the 3.5-inch HDD bay top cover
Ê Remove the 3.5-inch HDD bay top cover, see section "Removing the 3.5-
inch HDD bay top cover" on page 225).
Upgrade and Repair Unit
(URU)
Hardware: 20 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver