TX2550 M4 Upgrade and Maintenance Manual 437
System board and components
Figure 312: Removing the M.2 SSD (B)
Ê Pull the M.2 SSD out of its slot.
Ê If no new M.2 SSD will be installed:
Ê Fasten the screw to the corresponding bolt (see orange circles in figure
308) depending on the M.2 slot.
14.5.2.3 Concluding steps
Ê If applicable, "Installing an expansion card" on page 312
Ê "Installing the crossbar" on page 89
Ê If applicable, "Installing the riser module" on page 85
Ê "Installing the PCI air duct" on page 87
Ê "Installing the system air duct" on page 68
Ê "Reassembling" on page 68
Ê "Connecting the power cord" on page 81
Ê "Switching on the server" on page 82
14.5.3 Replacing the M.2 SSD
Upgrade and Repair Unit
(URU)
Hardware: 5 minutes
Tools: – Phillips PH1 / (+) No. 1 screw driver
To Next Page
Loading...
