Fujitsu PRIMERGY TX2550 M4 - Replacing a CPU or Heat Sink

TX2550 M4 Upgrade and Maintenance Manual 365
Processor (CPU)
Ê "Resuming BitLocker functionality" on page 127
11.3 Replacing a CPU or heat sink
V CAUTION!
CPUs are modules which are extremely sensitive to electrostatic
discharges and therefore must always be handled with care. After a CPU
has been removed from its protective sleeve or from its socket, place it
with its smooth side down on a non-conducting, antistatic surface. Never
push a CPU over a surface.
11.3.1 Preliminary steps
Ê "Locating the defective server" on page 49
Ê "Suspending BitLocker functionality" on page 105
Ê "Shutting down the server" on page 52
Ê "Disconnecting the power cord" on page 53
Ê "Getting access to the component" on page 54
Ê "Removing the system air duct" on page 67
Field Replaceable Unit
(FRU)
Hardware: 15 minutes
Software: 5 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver