Fujitsu PRIMERGY TX2550 M4 - Installing a 3.5-Inch HDD SAS Backplane

230 Upgrade and Maintenance Manual TX2550 M4
Hard disk drive (HDD) / solid state drive (SSD)
7.4.9.4 Installing a 3.5-inch HDD SAS backplane
Figure 144: Installing the new 4x 3.5-inch HDD SAS backplane (A)
Ê Fit the SAS backplane into the guide on the outer wall of the HDD bay (see
close-up) and lower it into the bottom rim.
Figure 145: Installing the new 4x 3.5-inch HDD SAS backplane (B)
Ê Ensure that the 4x 3.5-inch HDD SAS backplane is properly seated into the
bottom rim and side guide (see arrows).