TX2550 M4 Upgrade and Maintenance Manual 309
Expansion cards and backup units
Figure 215: Removing the OCP module (B)
Ê Remove the four screws (1).
I When replacing an OCP module: keep the screws for installing the
new OCP module.
Ê Remove the OCP module (2).
Ê Install the slot cover in slot 8.
Ê Install the OCP carrier into the OCP module slot.
9.4.2.3 Concluding steps
Ê If applicable, install the riser module, see section "Installing the riser module"
on page 85.
Ê "Reassembling" on page 68
Ê "Connecting the power cord" on page 81
Ê "Switching on the server" on page 82
To Next Page
Loading...
