Fujitsu PRIMERGY TX2550 M4 - Installing the Dummy Cover; Concluding Steps

146 Upgrade and Maintenance Manual TX2550 M4
Power supply unit (PSU)
6.2.2.4 Installing the dummy cover
Figure 70: Installing a dummy cover
Ê Insert the dummy cover into the empty bay with the impressed arrow symbol
facing up (see circle).
Ê Push the dummy cover into its bay until it locks in place.
V CAUTION!
Always install dummy covers into unused bays to comply with
applicable EMC regulations and satisfy cooling requirements.
6.2.2.5 Concluding steps
Ê No steps needed.