Fujitsu PRIMERGY TX2550 M4 - Removing Backup and Optical Disk Media

108 Upgrade and Maintenance Manual TX2550 M4
Basic software procedures
I For more information on how to access the BIOS and modify settings,
see the corresponding BIOS Setup Utility reference manual.
Configuring boot watchdog settings using the iRMC web interface
Ê Enter the ServerView iRMC web interface.
Ê Select the Server Management menu.
Ê Under Watchdog Settings select Continue from the Boot Watchdog drop down
list.
Ê Click Apply for the changes to take effect.
I For more information on iRMC settings, see the iRMC user guides.
5.1.3 Removing backup and optical disk media
Ê Ask the system administrator to eject all remaining backup or optical media
from the backup or optical disk drive before removing it from the server.
Ê If the backup media cannot be ejected by conventional means, and it is
mandatory that the cartridge be removed prior to returning the drive for
repair or disposing it, a manual tape extraction needs to be performed.
For more information on "forcible" tape ejection, see the "Tape Facts" pages
available to Fujitsu service partners from the following https address:
https://partners.ts.fujitsu.com/com/service/ps/Servers/PRIMERGY/Pages/
TapeFacts.aspx
For Japan:
Please contact Fujitsu support, if "forcible" tape ejection is necessary.
I Fujitsu does not assume responsibility for any damage to the tape
drive, the data cartridge/tape or for the loss of any data resulting from
manual tape extraction procedures.