Fujitsu PRIMERGY TX2550 M4 - Upgrading with Non-Hot-Plug Hdds;Ssds; Preliminary Steps

TX2550 M4 Upgrade and Maintenance Manual 273
Hard disk drive (HDD) / solid state drive (SSD)
Ê "Resuming BitLocker functionality" on page 127
Ê "Switching on the server" on page 82
7.7.2 Upgrading with non-hot-plug HDDs/SSDs
7.7.2.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 105
Ê "Shutting down the server" on page 52
Ê "Disconnecting the power cord" on page 53
Ê "Getting access to the component" on page 54
Ê "Removing the system air duct" on page 67
Ê Remove the fan bridge, see section "Handling fan bridges" on page 90.
7.7.2.2 Upgrading with non-hot-plug HDDs/SSDs
Ê Install the non-hot-plug HDDs/SSDs, see section "Installing a non-hot-plug
HDD/SSD" on page 271.
Ê Install the non-hot-plug cage, see section "Installing the non-hot-plug cage"
on page 271.
Customer Replaceable Unit
(CRU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver