322 Upgrade and Maintenance Manual TX2550 M4
Expansion cards and backup units
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 320.
Ê If applicable, restore LAN teaming configurations, see section "After
replacing/upgrading LAN controllers" on page 131.
9.6 Expansion cards in riser modules
9.6.1 Installing an expansion card in the riser module
9.6.1.1 Preliminary steps
Ê "Suspending BitLocker functionality" on page 105
Ê "Disabling the boot watchdog functionality of ServerView Operations
Manager" on page 106
Ê "Shutting down the server" on page 52
Ê "Disconnecting the power cord" on page 53
Ê "Getting access to the component" on page 54
Ê "Removing the riser module" on page 84
Ê "Installing the riser card" on page 83
Upgrade and Repair Unit
(URU)
Hardware: 10 minutes
Tools: Phillips PH2 / (+) No. 2 screw driver
To Next Page
Loading...
