Fujitsu PRIMERGY TX2550 M4 - Concluding Steps; Removing a PSU; Preliminary Steps; Note for Servers Using CMA (Cable Management Arm)

142 Upgrade and Maintenance Manual TX2550 M4
Power supply unit (PSU)
Figure 65: Installing the cable tie
Ê Push the cable tie into the corresponding hole until it clicks in.
6.2.1.4 Concluding steps
Ê "Connecting the power cord" on page 81
Ê If applicable, configure the redundant power supply.
Ê "Performing a fan test" on page 133
6.2.2 Removing a PSU
6.2.2.1 Preliminary steps
Ê Only when replacing a PSU in a non-redundant configuration: "Shutting
down the server" on page 52
6.2.2.2 Note for servers using CMA (Cable Management Arm)
Regarding of removing PSUs, additional tasks are needed, due to an
interference between CMA stopper and the PSUs.
Customer Replaceable Unit
(CRU)
Hardware: 5 minutes
Tools: tool-less