328 Upgrade and Maintenance Manual TX2550 M4
Expansion cards and backup units
9.6.3.3 Installing the expansion card
Ê If applicable, "Installing a slot bracket" on page 295
Ê Install the expansion card, see section "Installing an expansion card in the
riser module" on page 322.
9.6.3.4 Concluding steps
Ê "Installing the riser module" on page 85
Ê "Reassembling" on page 68
Ê Connect all external cables to the replaced expansion card.
Ê "Connecting the power cord" on page 81
Ê "Switching on the server" on page 82
Ê "Enabling replaced components in the BIOS" on page 121
Ê Inform the customer about changed WWN, MAC and SAS addresses, see
section "Looking up changed MAC/WWN addresses" on page 129.
Ê "Updating the NIC configuration file in a Linux and VMware environment" on
page 126
Ê "Updating expansion card firmware" on page 113
Ê "Enabling SVOM boot watchdog functionality" on page 121
Ê "Resuming BitLocker functionality" on page 127
Ê If applicable, reconfigure your network settings in the operation system
according to the original configuration of the replaced controller (expansion
card or onboard).
I Configuration of network settings should be performed by the
customer. For more information, see section "Note on network
settings recovery" on page 320.
Ê If applicable, restore LAN teaming configurations, see section "After
replacing/upgrading LAN controllers" on page 131
To Next Page
Loading...
