TX2550 M4 Upgrade and Maintenance Manual 279
Hard disk drive (HDD) / solid state drive (SSD)
Example 8x 3.5-inch HDDs and HDD extension box
Figure 191: Connecting cables to expander board
Ê Connect the cables:
Ê If applicable, connect the OOB cable, see section "Replacing the OOB
cable" on page 488.
I For more information about connecting SAS cables to the corresponding
controller see section "Expansion cards and backup units" on page 291.
I For the cable plan see chapter "Appendix B" on page 517.
1
SAS cable C10 from SAS expander board connector X1 to the
connector MLC1 on the SAS controller
2
SAS cable C10 from SAS expander board connector X2 to the
connector MLC2 on the SAS controller
3/4/5 SAS cable C11 from SAS expander board connectors X10 / X11 /
X12 to the backplane connectors X9
6 Power cable C26 from SAS expander board connector X3 to
backplane 1 connector X17
7/8/9 Power cables C6 from backplane connectors X40 to system board
connectors "PWR1", PWR2", and "PWR3"
To Next Page
Loading...
