TX2550 M4 Upgrade and Maintenance Manual 469
Converting a floorstand model to a rack model
Ê Lift off and remove the right side cover.
I The right side cover is no longer required.
Ê Leave the server in its upside down position.
Removing glider feet
Figure 333: Removing glider feet
Ê Using a slotted screw driver, slightly pry up on each glider foot until it
detaches.
Ê Bring the server back to its horizontal position.
I At least two people are needed to turn over a fully equipped server.
Remove HDDs and PSUs in order to facilitate the task.
To Next Page
Loading...
