Hioki 8423 - List Display Settings

7.3 Changing Display Settings
148
This section describes setting the display format of the list display area.
1. Click the [Execute] button to switch to list display or waveform plus list display.
2. Set various list display settings.
Display Content You can select the content of the list display area.
Display Type (When logging is selected for the display content)
Display Interval (When logging is selected for the display content)
Selection range: 1 to 1000
7.3.3 List Display Settings
(1) Click
(2) Set
List Display
Selectable
Items
Explanations
Logging
Display measurement values in the list display area. When logging
is selected, set the display type and display interval (thinning inter-
val) for the selected sheet.
Calculation Display list calculation results in the list display area.
Selectable
Items
Explanations
Analog Display analog data only.
Logic Display logic data only.
Alarm Display alarm data only.
Wave
Calculation
Display waveform calculation data only.
All Display all data.