Hioki 8423 - 10.8 Port Number

185
Chapter 10 Setting Method for Logger
10
You can switch the instrument to setting mode and perform the following tasks. Use the three keys on the
front for operation.
Setting Method
for Logger Chapter 10
"10.2 Synchronized Measurement" (p. 187)
"10.3 Date" (p. 188)
"10.4 Time" (p. 189)
"10.5 DHCP" (p. 190)
"10.6 IP Address" (p. 191)
"10.7 Subnet Mask" (p. 192)
"10.8 Port Number" (p. 193)
"10.9 Gateway" (p. 194)
"10.10 Display Language" (p. 196)
"10.11.1 ROM Check" (p. 197)
"10.11.2 RAM Check" (p. 198)
"10.11.3 BUS Check" (p. 199)
"10.11.4 Key Check" (p. 200)
"10.11.5 LED Check" (p. 201)
"10.11.6 LCD Check" (p. 202)
Settable Items
Self Check
"10.12.1 ROM Version" (p. 203)
"10.12.2 FPGA Version" (p. 204)
"10.12.3 MAC Address" (p. 205)
"10.12.4 Serial No." (p. 206)
Display of Individual Information
"10.13.1 Writing a Setting File" (p. 207)
"10.13.2 Reading a Setting File" (p. 208)
Setting Files
Items other than the above (recording intervals, filter settings, measurement set-
tings, trigger settings, etc.) cannot be set with the keys of the instrument. Con-
nect a computer and use the supplied software Logger Utility to configure or
change such settings.