Save data to the CF card
Viewing Saved Data
Read the measurement data (p. 169)
Read the setting data (p. 170)
From Start to End of Measurement
At the time
of purchase
Preparing for Measurement
Start the software Logger Utility
Install and connect the instrument (p. 31)
Install the software on the PC (p. 18)
Disconnect the communication cable from the
instrument
Start measurement with the button of
Logger Utility
Start measurement with of the
Memory HiLogger
Stop measurement with the button
Stop measurement with
Setting Measurement Conditions
Register the logger in Logger Utility (p. 64)
Set the IP address and other communication settings
Set the measurement conditions (p.74 to p.126)
Send the settings to the instrument (p. 127)
For LAN
communica-
tion only
Load and display the measurement data
on the computer
Obtain and save data
in real time
Computer Based Measurement (p. 135)
Standalone Measurement (p. 137)
To Next Page
Loading...
