10.7 Subnet Mask
192
This section describes setting the subnet mask for LAN communication. See
"LAN Connection Examples" (p. 71).
1. Turn the power on while pressing
and then release the key
when the model name and version
appear in the display area.
The instrument enters setting mode.
2. Press multiple times until the following subnet mask setting screen
appears.
3. Press to move the flashing cursor to the position to change.
Each press of the key moves the flashing cursor to the right.
4. Press to increase the value at the flashing cursor in increments of 1.
The value cannot be decremented.
5. Press to move the flashing cursor to [SET], and press to con-
firm the setting.
6. Press multiple times until the following setting mode end screen
appears.
7. Press to end setting mode.
A setting for separating an IP address into the address portion that indicates the
network and the address portion that indicates the device. Set the same setting
as that of the subnet mask of devices within the same network. If DHCP is set to
ON, the setting is configured automatically.
10.7 Subnet Mask
To Next Page
Loading...
