10.5 DHCP
190
This section describes setting DHCP for LAN communication to ON or OFF.
See "LAN Connection Examples" (p. 71).
1. Turn the power on while pressing
and then release the key
when the model name and version
appear in the display area.
The instrument enters setting mode.
2. Press multiple times until the following DHCP setting screen
appears.
3. Press to select ON or OFF for DHCP.
Each press of the key toggles the selection item.
4. Press multiple times until the following setting mode end screen
appears.
5. Press to end setting mode.
DHCP is a function that enables an instrument to automatically obtain informa-
tion such as its own IP address and configure the LAN settings accordingly. If
DHCP is set to ON and a DHCP server is running within the same network, it is
possible to automatically obtain the IP address, subnet mask, and gateway, and
configure the settings.
If the DHCP server is not running, the default IP address is assigned. If DHCP is
set to On and the IP address is not obtained from a DHCP server, it is automati-
cally set to Off.
10.5 DHCP
To Next Page
Loading...
