8.3 Automatically Transferring Measurement Data to Excel
172
• Real-time data transfer is not possible when more than 120 channels are
selected. Select no more than120 channels.
• During real-time data transfer, Logger Utility waveform calculations (Z1 to
Z60) cannot be changed.
• Attempting to use Excel during real-time data transfer may interfere with the
transfer and result in loss of measurement data. Avoid using Excel during data
transfer.
• If a sheet having the same name as the file specified for saving Logger Utility
measurements is already open in Excel, data is transferred into that sheet. If
such a sheet is not already open, one is created with the specified save file
name (but without appended serial number).
• If multiple sheets are open with the same file name, data will be transferred
into any sheet.
• The destination cell contents are cleared when transfer starts, and the cell for-
mat and display width are adjusted.
• When “Overwrite from the start cell...” is selected, and a data transfer is
delayed for more than one cycle, data acquired during the delay may be lost.
• Data transfer typically refreshes about once per second, but may be slower if
the Logger Utility and Excel processes are heavily loaded.
• When attempting to transfer data for many channels and lines, Excel may
exhaust available memory. In that case, reduce the amount of data to be
transferred.
8.3.2 Real-Time Transfer Example
To Next Page
Loading...
