2.3 Connect the instrument and computer with the USB cable provided
25
2
Chapter 2 Installing the Software
Please connect the instrument after installing the USB driver.
For Windows 2000/Vista/7
1. Connect the AC adapter to the instrument and switch on the power.
2. Connect the instrument and computer with the USB cable provided.
The HiLogger is automatically recognized, and preparations to use the
device are complete.
For Windows XP
1. Connect the AC adapter to the instrument and switch on the power.
2. Connect the instrument and computer with the USB cable provided.
A [Found New Hardware Wizard] dialog box will appear and the new hard-
ware detection wizard will begin.
3. Check [No, not this time] and click [Next].
2.3 Connect the instrument and computer with
the USB cable provided
Do not plug in or unplug the USB cable while the instrument is operating.
To Next Page
Loading...
