163
8
Chapter 8 Saving and Reading Data
You can save and read the data you measured and settings you configured with
Logger Utility. The file types and extensions that can be handled are shown
below.
Saving and
Reading Data Chapter 8
• When a waveform file (.LUW, .MEM) or index file (.LUI) is read, the display set-
tings file (.LUV) is also read together. If no display settings file exists, it is cre-
ated automatically. Furthermore, when the application ends, the setting
conditions are written automatically to the display settings file. However, when
reading data saved to, for instance, a CD, the display conditions cannot be
saved.
• When an index file (.LUI) is read, waveforms are not displayed if the waveform
file (.LUW) from the time of measurement does not exist. When copying or
moving files, be sure to copy or move both the index file and waveform file
together.
• A display file (.LUV) cannot be read by itself.
ABC.LUS
AUTO.LUI
AUTO.LUW
8423.MEM
AUTO.LUV
A setting file of Logger Utility.
An index file for the measurement data of Logger Utility. It is created
when the auto save mode is other than standard, and waveform files
such as AUTO.LUW and AUTO1.LUW are read simultaneously.
A display settings file for AUTO.LUW. It is created automatically
when reading is performed. The file cannot be read by itself.
A measurement file of Logger Utility. It is read together with AU-
TO.LUV.
A measurement file from measurement with 8423. When reading is
performed, the display settings file named WAVE.LUV is created.
Save Directory
ABC.LUS
AUTO.LUI
AUTO.LUV
AUTO.LUW
WAVE.MEM
To Next Page
Loading...
