10.11 Self Check
199
Chapter 10 Setting Method for Logger
10
This section describes checking the signal line of the internal circuitry of the
instrument. The result is displayed in the display area.
1. Turn the power on while pressing
and then release the key
when the model name and version
appear in the display area.
The instrument enters setting mode.
2. Press multiple times until the following BUS check screen appears.
3. Press to start the check.
If the result is normal, "PASS" is displayed. If the result is abnormal, "FAIL" is
displayed.
4. Press to end the display of the result.
5. Press multiple times until the following setting mode end screen
appears.
6. Press to end setting mode.
10.11.3 BUS Check
To Next Page
Loading...
