5.7 Setting Environment Conditions
123
5
Chapter 5 Setting Measurement Conditions
This section describes setting the method for saving data to a CF (compact
flash) card inserted in the logger.
1. Click the icon of the logger you want to change the settings of on the envi-
ronment settings page.
The background color of the selected icon turns red.
2. Configure the file (CF card) settings.
Select the auto save method.
Use the mouse to select the desired setting from the list.
Enter the file name.
Use the keyboard to enter the file name to use for saving to the CF card. Enter
up to 8 single-byte characters. If a file of the same name exists, a sequence
number is added to the file name.
Select the real-time save mode.
Use the mouse to select the desired setting from the list.
5.7.2 CF Card Save Settings
Selectable
Items
Explanations
OFF Do not save measurement data to the CF card inserted in the logger.
Binary
(real time)
Save measurement data in binary format to the CF card inserted in
the logger, while measuring.
Selectable
Items
Explanations
File Full
Ends saving when there is no longer much available space on the CF
card. However, measurement continues.
Delete and
Save
When the amount of available space of the CF card reaches a certain
level during measurement, the oldest file in the directory currently
being recorded to is deleted and the new data is saved. If a file was
unable to be deleted, the same operation as for [File Full] is per-
formed.
Go to the [Auto Save Mode] in the Measurement Setting page to carry out split
saving (p. 83).
To Next Page
Loading...
