3.5 Connecting a Communication Cable
44
When you want to measure via LAN, connect the instrument and computer with
the LAN cable. To ensure stable communication, do not connect the USB cable
when measuring via LAN.
Attaching the Ferrite Clamp
1. Wrap the LAN cable around the ferrite clamp once.
Attach the ferrite clamp at a position that is 2 to 4 cm away from the connector to
be connected to the instrument.
2. Close the ferrite clamp until a click is heard.
3.5.2 Connecting the LAN Cable
Adapter connector +
Model 9642 LAN Cable (straight)
100BASE-TX
connector
Lights when communication with the connected
device is possible.
Flashes when data is being exchanged.
When connecting via a hub:
HUB
Model 9642 LAN
Cable (straight)
When connecting the instrument and computer directly on a one-to-one-basis:
The 9642 LAN Cable is straight cable, so use the supplied adapter connector when
connecting the instrument and computer directly on a one-to-one basis.
Model 9642 LAN
Cable (straight)
• When you want to communicate between the instrument and computer via
LAN, configure the network settings of the instrument.
• When connecting to an existing LAN network, obtain the settings from the net-
work administrator.
• When the instrument will be affected by external noise, attach the supplied fer-
rite clamp as shown in the figure below.
To Next Page
Loading...
