10.11 Self Check
198
This section describes checking the storage RAM, backup RAM, and work RAM
of the internal memory (RAM) of the instrument in succession. The result is dis-
played in the display area.
1. Turn the power on while pressing
and then release the key
when the model name and version
appear in the display area.
The instrument enters setting mode.
2. Press multiple times until the following RAM check screen appears.
3. Press to start the check.
The check takes approximately 40 seconds. If the result is normal, "PASS" is
displayed. If the result is abnormal, "FAIL" is displayed.
4. Press to end the display of the result.
5. Press multiple times until the following setting mode end screen
appears.
6. Press to end setting mode.
10.11.2 RAM Check
To Next Page
Loading...
