Hioki 8423 - Configuring Basic Settings for Measurement; Setting Function and Recording Interval

5.3 Configuring Basic Settings for Measurement
77
5
Chapter 5 Setting Measurement Conditions
This section describes configuring basic settings for measurement such as the
recording interval (sampling speed) and recording period. The screen settings
differ depending on the sampling function you select.
On the measurement settings page, select the sampling function in accordance
with the purpose of measurement. The method for obtaining measurement data,
settings, and available functions differ depending on the sampling function. Sam-
pling cannot be set for the 8997 Alarm Unit.
Sampling is performed at a timing which is synchronized to the internal clock of
the logger, and the data is recorded. The measurement data quantity is the
same for all channels.
1. Click [Normal Sampling] on the measurement settings page.
2. Set the recording interval (high-speed).
5.3 Configuring Basic Settings for Measurement
5.3.1 Setting Function and Recording Interval
Normal Sampling
Recording interval
Selectable Intervals
10, 20, 50, 100, 200, 500 ms, 1, 2, 5, 10, 20, 30 s, 1, 2, 5, 10, 20, 30 m, 1 h
(3) Select
(1) Click
(2) Click