10.9 Gateway
195
Chapter 10 Setting Method for Logger
10
7. Press to move the flashing cursor to [SET], and press to con-
firm the setting.
8. Press multiple times until the following setting mode end screen
appears.
9. Press to end setting mode.
When connecting to a network: If the computer is on a different network than the
logger, set this to ON and specify the device that will be the gateway. If they are
connected to the same network, generally this should be set to same gateway as
the computer. When connecting directly to the computer: This setting is not nec-
essary if the computer and logger are connected to the same hub, so set it to
OFF. If DHCP is set to ON, the setting is configured automatically.
To Next Page
Loading...
