1.3 Names and Functions of Parts
13
1
Chapter 1 Overview
Key Operations
Keys Explanations
• The key lights during measurement.
• Press the key once during standby to start measurement.
• Press the key during measurement to input an event mark.
When the power is on:
You can initialize the settings by turning the power on while pressing and
.
See "13.3 Initializing Settings (System Reset)" (p. 233).
• Press the key twice in succession during measurement to stop measurement.
When the power is on:
You can initialize the settings by turning the power on while pressing .
See "13.3 Initializing Settings (System Reset)" (p. 233).
• Switches the display content.
• The key flashes while an error message or warning message is displayed. Press
the key once to clear the display.
• If the key is pressed for at least one second and then released while measure-
ment values are displayed during measurement, the display channels are fixed
to those displayed the instant the key was released. Press the key for at least
one second again to cancel fixing of the display channels.
When the power is on:
The instrument enters setting mode if you turn on the power while pressing .
See "Chapter 10 Setting Method for Logger" (p. 185).
To Next Page
Loading...
