Appendix 3 Error Display
A4
Warning Messages
37 There is a logger without a measurement
channel.
Check the channel configuration of the connected loggers.
38 The measurement stop time has elapsed. Set a measurement stop time that is later than the current time.
39 The recording period setting is incorrect. The recording period is set to 0. Set the recording period to other
than 0 or set continuous recording to ON.
40 The timer measurement setting is incorrect. The same value is set for the start time and stop time. Change
the value of one of them.
No. Messages Solution
No. Messages Solution
100 The application cannot be ended during
measurement.
Stop measurement if you want to end the application.
103 The AB cursors cannot move to this position. If cursors A and B are set to be moved at the same time, a cursor
cannot be moved to a position which will result in the other
cursor being outside the measurement data range. In such a
case, cancel the setting for moving the cursors at the same time.
104 The maximum number of event marks is not
set.
The maximum number of event marks is 1000. Delete
unnecessary event marks.
105 The selected channel cannot be used. The selected channel cannot be used for the corresponding
function. Select another channel. (Example: An alarm channel
cannot be specified as a gauge channel.)
500 Data that matched the search conditions
could not be found.
Change the search conditions.
To Next Page
Loading...
