4.1 Main Screen
55
4
Chapter 4 Software Screen
This area displays the measurement waveforms. You can also split the screen to
display two waveforms. The frame of the active screen is emphasized. See "7.3
Changing Display Settings" (p. 142).
Double-clicking a comment enables it to be set. Enter characters with the key-
board, and then press the Enter key.
This area displays measurement waveforms and calculation results as numerical
values.
Waveform Display Area
Upper limit value
Lower limit value
Gauge
Scroll bar
This indicates the positional relation for
displaying measurement waveforms. You
can drag the mouse to change a displayed
position.
Comment 1
Comment 2
List Display Area
Display content:
Allows for selecting logging
or calculation.
Sheet tab
If a display channel is pre-assigned to
each sheet, the sheet tabs allow you to
switch the display channels.
• Scrolling and changing sheets apply to the active screen.
• When logging is selected for the display content, you can select the display
type (analog, logic, alarm, waveform calculation, or all) for the next column on
the right. When logging is selected and an alarm setting is enabled, the alarm
status is displayed on the far left.
To Next Page
Loading...
