Filter Events 111
User Guide v 2.0 — March 2023 Heat the Mold
The information on the Event History screen is described in Table 9-5.
9.8.1 Filter Events
You can select the types of events you want to see from the Event History Filter window.
Refer to Figure 9-3.
To filter events, do the steps that follow:
1. On the Event History screen, touch the Filter button.
2. Select the filter type(s) you want to see on the Event History - Filter dialog window.
NOTE: Event types with check marks will be shown on the Event History screen.
3. Touch the Exit button.
Table 9-5 Event History Screen Information
Item Description
Filter Lets you select the type of events shown on the Event History screen. The
event types include:
• Zone Alarms (active and inactive)
• Alarms (active and inactive)
• Warnings (active and inactive)
• Setpoint Changes
• Setup (changes)
• HMI Startup
• Out of Specification (events)
Number of Events This number shows how many events are listed on the Event History
screen.
Date/Time The date and time that the event was triggered.
Source The cause of the event.
Description The description of the event.
Mold Shows the mold that is related with the mold setup that was loaded
when the event occurred.
Mold Setup Shows the mold setup that was loaded when the event occurred.
To Next Page
