v 2.0 — March 2023 Altanium Delta5
272 Intelligent Control Cards
16.3 Intelligent Control Cards
There are two series of intelligent control cards (ICC)s that the Delta5 is designed to work
with. These are the X-Series (ICC
2
) and H-Series intelligent control cards (ICC
3
). Refer to
Figure 16-7 and Figure 16-8. The X-Series card can be identified by the large square blue or
brown transformer mounted near the heatsink and is the older generation of Altanium cards.
The H-Series card can be identified by the yellow numbered label that indicates how many
zones it supports. H-Series cards are the newest generation of Altanium cards.
Although they look similar, the X-Series and H-Series cards are not compatible with each
other and must only be used in systems of the same card types.
Figure 16-7 X-Series Intelligent Control Card
Figure 16-8 H-Series Intelligent Control Card
IMPORTANT!
ICC
2
and ICC
3
cards almost look the same, but they use different backplanes and are not
compatible with each other.
IMPORTANT!
An Intelligent Control Card must be installed in the position labeled “1” in all card cages for
the system to function correctly.
To Next Page
Loading...
