v 2.0 — March 2023 Altanium Delta5
122 Wireless Network
3. Enter the necessary information in the fields to configure the network connection.
4. Touch the Update button.
The Connected indicator will show when the network connection has been made.
10.2.2 Wireless Network
To change the network settings for a wireless network, do the steps that follow:
NOTE: The controller does not have a built-in wireless adapter. To connect to a WiFi network,
a D-Link DWA-182 or DWA-171 wireless adapter must be connected to the controller.
Refer to Figure 10-5.
1. Touch the Setup button in the WIRLESS NETWORK section of the screen.
The Wireless Network Setup dialog shows. Refer to Figure 10-6.
2. Connect a D-Link DWA-182 or DWA-171 wireless adapter to the USB port on the
controller.
NOTE: After the D-Link wireless adapter is connected to the controller, it is
automatically detected by the HMI software. The connection status changes to
“Searching for Available Networks”. If there is one or more WiFi networks
available in the area, the connection status changes to “Ready to Select Network”
and enables the Network SSID.
3. Touch the Network SSID field and a list of all available WiFi networks will show.
Figure 10-5 D-Link DWA-182 or DWA-171 Wireless Adapters
Figure 10-6 Wireless Network Setup Dialog
To Next Page
Loading...
