Altanium Buttons 17
User Guide v 2.0 — March 2023 Altanium Operator Interface
4.1.3 Altanium Buttons
Altanium has a system header and a footer on every screen in the system.
4.1.3.1 Controller Function Buttons
Refer to Figure 4-1 for the Controller Function buttons location. Table 4-1 describes the
button functions.
Table 4-1 Controller Function Buttons
Button Description
Stop
Stops the power to all zones. This stops the power in all system conditions.
Start
Applies power to the zones that have a configured setpoint.
Standby
Puts the system in standby mode. If a timer is active, the time remaining is
shown in the status bar. This button is not available during Active
Reasoning Technology (ART) tuning.
Boost
Puts the system in boost mode. If a timer is active, the time remaining is
shown in the status bar. This button is not available during ART.
To Next Page
Loading...
