v 2.0 — March 2023 Altanium Delta5
244 Enable an I/O Option
14.1.1 Enable an I/O Option
The system comes standard with the ability to configure up to four I/O heats options. If an
option package is included with the system, the options must be enabled. The system only
lets you enable the number of purchased options. To enable a different option when the
system is at the purchase limit, disable one of the options and then enable a different option.
To enable an option, touch the In Use checkbox for the option. A check mark shows if the
option is on.
To disable an option, touch the check mark in the In Use checkbox to clear it.
14.2 Safety Signals (UltraSync-E or Altanium Servo Control Installed)
The safety signals are monitored to make sure the system does not continue to operate in an
unsafe condition. These are locked signals, so you cannot modify the name, invert the signal,
or force the signal.
These signals are only available when the controller is configured with UltraSync-E or
Altanium Servo Control.
Table 14-2 describes the safety signals.
Table 14-2 Safety Signals
Signal Description
IMM E-Stop OK This signal from the IMM tells the Delta5 system that the IMM E-Stop is in
correct operation. If an IMM E-Stop button is pushed, the indicator
would not be illuminated.
IMM Safety Gates Closed This signal from the IMM tells the Delta5 system that all of the IMM safety
gates are closed. If an IMM safety gate is open, the indicator would not
be illuminated.
Controller E-Stop OK This signal shows the Delta5 system E-Stop is in correct operation. If
there was a problem with the E-Stop function, the indicator would not
be illuminated.
Bench Mode Plug
Installed
This indicator is for Husky Technical Support only.
To Next Page
Loading...
