Husky Altanium Delta5 - Remove and Replace the Operator Interface

v 2.0 — March 2023 Altanium Delta5
288 Remove and Replace the Operator Interface
16.4.3 Remove and Replace the Operator Interface
To remove and replace the operator interface, do the steps that follow:
1. De-energize the system at the Altanium main power switch. Refer to Figure 16-2.
2. Lock out and tag the main power switch in accordance with local codes.
3. At the bottom of the MCU enclosure, find and disconnect the Power and
Communication connectors that come from the controller mainframe. Refer to
Figure 16-21.
WARNING!
Electrical and mechanical hazard- risk of death, serious injury and/or damage to the
equipment. Turn off all power to the system and disconnect it completely from the
main input power.
Figure 16-21 Operator Interface Connectors