Remove and Replace the MCU 287
User Guide v 2.0 — March 2023 Maintenance
11. Securely hold the MCU and slide it down onto the mounting bracket, so the top MCU
screws go into the bracket slots.
12. Rotate the touch monitor to the full back position. Refer to Figure 16-18.
13. Install the two bottom socket cap screws and tighten them with the 4 mm right-angle
Allen key or hex wrench.
14. Rotate the touch monitor to the full forward position.
15. Tighten the two top socket cap screws with the 4 mm right-angle Allen key or hex
wrench.
16. Connect the Touch Screen Signal, Touch Monitor Power, and VGA or LCD1 (HDMI)
connectors at the bottom of the MCU enclosure.
17. Connect all other cables to the bottom of the MCU enclosure if your system has other
options.
18. Remove the lock out equipment and tag from the main power switch.
19. Energize the system at the main power switch.
To Next Page
Loading...
