Husky Altanium Delta5 - Heats Digital Outputs

Heats Digital Outputs 251
User Guide v 2.0 — March 2023 System Options
14.4.2 Heats Digital Outputs
The Heats tabs (Heats Page 1 and Heats Page 1) show screens with the digital outputs to the
IMM that are related to heats operation. Refer to Figure 14-4.
Controller Function • Fault Stop Immediately
• Fault Stop End Of Cycle
• Calibration Active
• Process Outside Limit
• All Axes At Standstill
--
Configurable Signal Configurable signal 1 - 24 - -
UltraSync-E
(if installed)
• UltraSync-E Stems At Closed
• UltraSync-E Stems At Open
• UltraSync-E Ready and Engaged
• UltraSync-E Stems Position
--
Temperature Control At Temperature - -
Table 14-7 Servo Digital Output Selections (Continued)
Signal Type Signal Condition Position
Figure 14-4 Digital Outputs Screen (Heats Page 1)