Husky Altanium Delta5 - Power Conservation; Part Counting; Set Part Counting

Power Conservation 149
User Guide v 2.0 — March 2023 System Setup
4. Type the number of days and touch the Accept button.
5. Touch the Change Reminder checkbox to enable the reminder.
6. When asked, “Are you sure?”, touch the Accept button.
7. Touch the Exit button.
10.7 Power Conservation
To conserve power, the Altanium controller lets you set the display to automatically turn off
(change to a dark screen) if it is not used in a set interval of time. When it turns off, touch the
screen to turn it on again.
To enable the power conservation feature and set the timer, do the steps that follow:
1. On the System Setup screen, touch the Main 2 tab.
2. Touch the Turn Off Display After field.
3. Type the number of minutes from 1 to 300 and touch the Accept button.
4. Touch the Turn Off Display checkbox, so the check mark shows.
The power conservation feature is now enabled.
10.8 Part Counting
Optional digital inputs and an output are available to automatically count parts. The system
also lets you set a sack full limit, so users do not have to manually calculate when the sack is
full.
10.8.1 Set Part Counting
To set Part Counting, do the steps that follow:
1. On the System Setup screen, touch the Heats Setup tab and then the Control Page 2
tab.
2. Touch the Setup button below Part Counting.
The Part Counting - Setup dialog window shows. Refer to Figure 10-21.
3. Touch the Assign Heater Types button if this was not done before. This will show the
Quick Set screen. For more information refer to Section 7.8.
NOTE: The Heater Type parameter must be set to Tips for all zones of a cavity in the
mold. If no zones have a Heater Type parameter assigned, an error message will
show.
4. Touch the Part Counting Enable checkbox, so the check mark shows.