Husky Altanium Delta5 - System Status Field; Navigation Buttons

v 2.0 — March 2023 Altanium Delta5
18 System Status Field
4.1.3.2 System Status Field
Refer to Figure 4-1 for the System Status field location. Table 4-2 describes the System Status
Field information.
4.1.3.3 Navigation Buttons
Refer to Figure 4-1 for the Navigation buttons location. Table 4-3 describes the Navigation
button functions.
Table 4-2 System Status Field
Button Description
System Ready To Mold
When the system starts, this status bar shows the progress as the mold
zones heat to the At Temperature setpoint. The status bar and label do not
show after the zones get to the At Temperature setpoint.
At Temperature
This gives an indication of what follows:
• Flashes while the controller applies heat to the zones as they increase
in temperature to the setpoint.
• Solid when all automatic zones are “At temperature”.
• Off if the controller is in the “Stop” state.
Company Name
The company name is shown.
System Mode
Shows the current mode of the system. For a description of each system
mode, refer to Section 4.1.5.
System Timer
Shows the timer value.
Table 4-3 Navigation Buttons
Button Description
Back
To see the previous screen (maximum of 10 screens back).
NOTE: The Home Screen is not included as part of the navigation history.
Forward
To see the next screen (maximum of 10 screens forward).
NOTE: The Home Screen is not included as part of the navigation history.