Husky Altanium Delta5 - Input Wiring (Conventional); Purpose of the Equipment; Restrictions of Use

Purpose of the Equipment 3
User Guide v 2.0 — March 2023 Introduction
1.2 Purpose of the Equipment
Husky controllers are designed to control the process temperature for injection molding
applications only.
Contact your nearest Husky Regional Service and Sales office if you plan to use a Husky
product for anything other than its intended use.
1.3 Restrictions of Use
Husky injection molding equipment must never be:
• Used for any purpose other than that described in Section 1.2, unless otherwise
approved by Husky
• Operated or serviced by personnel unfamiliar with the inherent risks and necessary
precautions related to controllers
1.4 Input Wiring (Conventional)
Table 1-1 summarizes the wiring conventions used.
Table 1-1 Electrical Wire Standards
Description Wire Color
Neutral Blue
Earth/Ground Green/Yellow Green
Line Black Black
Line Brown Red
Line Gray White
DANGER!
Electrocution and/or mechanical hazard - risk of death or serious injury and possible
damage to the equipment.
Incorrectly wiring the controller could cause death or serious injury and/or damage to
the controller or hot runner. Only qualified personnel should connect the electrical
power supply. All work must conform to applicable local electrical codes.