Dashboard Interface 125
User Guide v 2.0 — March 2023 System Setup
10.2.4 Dashboard Interface
The Dashboard Interface panel of the Network screen lets you enable the interface and enter
the IP address of the dashboard server. The dashboard connection status and disconnected
status are also shown.
Touch the Setup button on the Dashboard Interface panel, and the Dashboard Interface
Configuration dialog shows. Refer to Figure 10-9.
Connection Status A status field that notifies the user of the current state of the network share
connection. Possible values are:
Not Connected The system is not connected to the specified
network share.
Undefined Location The Location field has no value specified.
Connecting The system does the operation to connect to the
specified network share.
Connected The system has connected to the specified
network share.
Unable to Connect The system could not connect to the specified
network share. See the 'Error Code' field.
Disconnecting The system does the operation to disconnect from
the specified network share.
Unable to Disconnect The system could not disconnect from the
specified network share. Refer to the Error Code
field.
Network Unavailable The connection to the network stops. This occurs if
the network cable becomes unplugged or there is
an issue with the network adapter.
Error Code This field reports the error code returned by the Windows operating system
when the controller tries to connect to, or disconnect from, a network
share. This will be used to troubleshoot any problems that occur with the
use the networking feature. There are approximately 16,000 documented
error codes, so it is not possible to list and describe each one. Here are two
examples as a reference:
85 The local device name is already in use.
2250 The network connection does not exist.
Connect Button Used to initiate a connection to the specified network share.
Disconnect Button Used to remove the current connection to the specified network share.
Table 10-3 Network Configurations (Continued)
Item Description