Heats Setup - Control Page 2 141
User Guide v 2.0 — March 2023 System Setup
10.3.2 Heats Setup - Control Page 2
On the Control Page 2 tab of the Heats Setup screen, configurations are set for the categories
that follow:
• Part Counting
• SPI
• Thermocouples
• Auto Following
• Zone Slot Configuration
The Control Page 2 tab is shown in Figure 10-17 with the configuration settings for each
category. The configuration settings are described in Table 10-9.
Figure 10-17 Heats Setup - Control Page 2
Table 10-9 System Setup Screen - Heats Setup - Control Page 2
Item Description
Part Counting Used to automatically count parts and to set a sack full limit.
SPI If a device is attached to the SPI connector, this section lets you
enable communication with the device and set the
communication protocol.
Display Thermocouple
Reading for Manual Zones
A global setting that controls if the controller view screens show
the thermocouple readings for zones in manual mode.
Same Thermocouple
Assignment Maximum Limit
Sets the maximum number that a user can assign for the
Thermocouple Assignment value setting on the Quick Set screen.
Auto Following Enable Enables or disables Auto Following function.
To Next Page
Loading...
