System Setup - Main 1 and Main 2 Settings 119
User Guide v 2.0 — March 2023 System Setup
User Settings Touch the Configure button to set the items that follow:
Language The language used on the Altanium user interface.
Force
Temperature
Units to
Forces the temperature units to specified setting.
Units Used to set the units of measure (SI or Imperial)
shown on the Altanium user interface.
Date and Time The date and time shown on the Altanium user
interface.
Time Zone The time zone shown on the Altanium user
interface.
Automatic
Daylight Saving
Automatic daylight savings on/off checkbox.
Log Transfer Transfer data log or event log in CSV format to a specified log file
destination. The complete log is transferred, or a time range can be set.
Diagnostics Export Used to export diagnostics files to a USB drive. This is for Husky Technical
Support use only. Contact Husky for help, if necessary.
Air Filter Used to set a reminder interval for the air filter replacement.
License Number The license key is shown.
Update License Used to upload new license file from Local, USB, and Network drives.
View License Shows the license information.
Remote Load This panel is used to select the mold setups that can be loaded directly
from the injection molding machine. Identifies the loaded mold setup ID
and indicates that the remote file has been loaded.
Acknowledge Alarm Used to set a signal (example: digital input) to acknowledge alarms, so
the user does not have to press the alarm reset button.
Forced I/O Warning
Enable
When enabled, a “Channel Forced” warning is shown when a signal is
forced. This option applies to all signals able to be forced. The warning
source will be a signal group. The default setting is enabled.
Table 10-1 System Setup - Main 1 Screen Items Descriptions (Continued)
Item Description
To Next Page
Loading...
