v 2.0 — March 2023 Altanium Delta5
202 Data Collection Stop Conditions
Table 12-5 Cycle Mode - Conditions to Stop (UltraSync-E or Altanium Servo Control Installed)
Heats Running
Condition
Enabled
UltraSync-E
Engaged
Condition
Enabled
Mold Servo
Controller
Engaged
Condition
Enabled
Cycle Mode
Conditions
Selection
Shown on
Screen
Conditions to Stop
Yes Yes No Yes If pair of digital inputs (start and end)
• End digital input does not go
high before the cycle time limit
has expired
• Heats are turned off or not At
Temperature
• UltraSync-E is disengaged or
disabled
System changes to timed data
collection
If one digital input to start and timer
to end data collection:
• Start digital input is not high
again before the cycle time limit
has expired
• Heats are turned off or not At
Temperature
• UltraSync-E is disengaged or
disabled
System changes to timed data
collection
If one digital input to start and end
data collection:
• Start digital input does not go
high again before the cycle time
limit has expired
• Heats are turned off or not At
Temperature
• UltraSync-E is disengaged or
disabled
System changes to timed data
collection
To Next Page
Loading...
