Chapter 8 Maintenance and Inspection 8.5 Grease Supply
277
[Z-axis Step (3)]
Move the slider on the Z-axis to the
home-position, and supply grease
with using a grease gun.
[Tool: Grease gun]
<Caution>
During supplying grease, hold the Z-
axis or turn the servo on so the Z-
axis will not move.
[Z-axis Step (1)]
View the Z-axis from the front, and
take out the rubber cap on the right.
[Z-axis Step (2)]
Confirm the grease nipple on the
right side of the Z-axis slider.
Grease should be supplied to the
guide and ball screw on the right
side.
Z-Axis
Rubber Cap
Grease Nipple
Grease Gun
To Next Page
Loading...