ICON A5 - Page 264

9-28 FLIGHT CONTROLS / ROLL CONTROLS
ICON A5 / MAINTENANCE MANUAL CHANGE C3
CHAPTER 9
RELATED INFORMATION:
"Inspect Roll Cable Tension" on page 9-13
"Cockpit Floor Board Removal" on page 3-46
"Cockpit Floor Board Installation" on page 3-47
"Seat Back Removal" on page 3-50
"Seat Back Installation" on page 3-51
"Seat Pan Removal" on page 3-52
"Seat Pan Installation" on page 3-53
"Baggage Floor Removal" on page 3-41
"Baggage Floor Installation" on page 3-42
"Seat Belt Inertia Reel Removal" on page 3-39
"Seat Belt Inertia Reel Installation" on page 3-40
"Baggage Sidewall Panel Removal" on page 3-43
"Baggage Sidewall Panel Installation" on page 3-45
"Headliner Removal" on page 3-37
"Headliner Installation" on page 3-38
"Inspect Roll Rigging" on page 9-17
"Removal and Installation of Inspection Panels and Fairings" on page 3-34
"Cockpit Panels Removal and Installation" on page 3-36
9.4.4.2 Remove Roll Cables
Use the following task to remove any upper or lower control cables that fall outside of the acceptable
conditions.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
LSA-RM
Task Specific Training Required
No
Special Tools Required
None
Parts Required
None
Aircraft System and Number
06—Flight Controls
Consumables
None
See “Inspect Control Cables” on page 9-8.