16-38 PROPULSION / ENGINE
ICON A5 / MAINTENANCE MANUAL CHANGE C2
7. Check in the full throttle position that the throttle lever has at least .050 inches clearance.
• In cockpit, move throttle handle to full throttle position (FWD stop). At engine, ensure the
lever full throttle stop contacts the throttle body before the throttle handle contracts the
FWD stop. (See Figure 16-23.)
NOTE: The throttle lever on the engine is spring loaded to the full open
position.
8. Adjust position of cable in cable fixation fastener as required. (See Figure 16-24.)
FIGURE 16-24
THROTTLE CABLE FIXATION FASTENER
9. When cable adjustment is complete, torque cable fixation fastener to 35±5 in-lb. Check that
hardware is secure.
CAUTION: Ensure not to damage the bushing by over torquing cable fixation
screw.
10. Inspect for any loose bolts. (See Figure 16-21.)
11. Replace throttle bezel. (See “Throttle Handle and Bezel Removal” on page 8-10.)
12. Replace engine cowl. (See “Remove Engine Cowlings” on page 16-13.)
VERIFICATION METHOD:
Verify that all checks listed above are within acceptable limits. If full travel not able to be obtained,
contact ICON owner support.
To Next Page
Loading...
