ICON A5 - Page 728

16-104 PROPULSION / PROPELLER
ICON A5 / MAINTENANCE MANUAL CHANGE C2
CHAPTER 16
RELATED INFORMATION:
"Condition and 100-Hour Inspection—Engine and Propeller" on page 3-21
"Propeller Assembly" on page 16-93
"Propeller—Minor Blade or Hub Repair" on page 16-104
16.2.4.5 Propeller—Minor Blade or Hub Repair
Instructions for minor repairs to Sensenich propeller blades and hubs.
TASK INFORMATION:
Type of Maintenance
Line
Level of Certification
A&P
Task Specific Training Required
No
Special Tools Required
Calibrated Torque Wrench
Parts Required
See Task Instructions
Aircraft System and Number
13—Propulsion
Consumables
None
TASK INSTRUCTIONS:
1. Remove propeller assembly from engine. (See “Propeller Removal From Engine” on page 16-102.)
2. Perform repair in accordance with the latest revision of Sensenich Propellers document 3B0R5.
Verify that damage is within acceptable limits before performing repair.
a. Blade repairs are to be made in accordance with ‘MINOR BLADE REPAIRS’ procedure.
b. Hub repairs are to be made in accordance with ‘MINOR HUB REPAIRS’ procedure.
3. Reinstall propeller assembly onto the engine. (See “Propeller Installation Onto Engine” on page
16-103.)
VERIFICATION METHOD:
Visually examine that damage and repair and within the limits specified in the Sensenich document.